See the CONFIG Menu, LIN OUT to adjust level. Normal is 010.
73
Bob, K4TAX
K3S S/N 10163
On 6/22/2017 12:31 PM, Dick via Elecraft wrote:
Hello Elecraft,
When feeding the audio from the K3S USB port to the CPU, the K3S audio
level is extremely high and way too hot for good performance on many digital
modes.
Example, even with my CPU's sound card set at the lowest possible level of
"01" my K3S is hitting the JT-65 software with a super strong signal that
is much higher than the software wants to see and performance is degraded.
The same is true when operating RTTY using MMTTY or 2Tone software.
The USB audio output on the K3S needs to be adjustable in the K3S Menu as
it was on the K3 Serial port.
I wrote to you a few months ago about this without a positive reply.
Please address this serious issue.
Thank you-
Richard Van Zandt- K9OM
In a message dated 6/2/2017 7:28:48 P.M. Central Daylight Time,
[email protected] writes:
If you are using Line Out with a fixed gain setting to feed audio to
WSJT-X, adjusting the AF control will not do anything. What I do is leave
my RF gain control at its normal position (around 3 o'clock) and use the
slider at the lower left in the WSJT-X window to compensate for gain
variations.
73,
Rich VE3KI
W3FPR wrote:
Bret,
You may have better luck with running the RF Gain full and adjusting
with the AF gain. That way the RX AGC will smooth out variations in the
signal level.
73,
Don W3FPR
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
