Richard, I agree with Don, perhaps the extreme high setting, which is well beyond your highest voice frequency may have something to do with the lack of effectiveness. I would add that the gain at 2400 is extraordinary as well. 10 db of audio increase, if I recall correctly from my technical training (Signal Corp '69-72), is like doubling the perceived volume. That is a lot. Of course, this doesn't take your mic into consideration. 73, Bill K9YEQ
-----Original Message----- From: Don Wilhelm <[email protected]> Sent: Sunday, March 18, 2018 12:25 PM To: Richard <[email protected]>; Bill Johnson <[email protected]> Cc: Elecraft Reflector <[email protected]> Subject: Re: [Elecraft] K3S TX Noise Gate Richard, Remove the boost on the high end. You can reduce all bands if you want to maintain the same curve. It is better not to boost, but cut instead. 73, Don W3FPR On 3/18/2018 1:09 PM, Richard wrote: > Bill, > > Tx EQ: > 50 = -16 > 100 = -12 > 200 = -6 > 400 = 0 > 800 = 0 > 1200 = +3 > 2400 = +9 > 3200 = +12 > > This works well for me. > > Richard - W4KBX > > >> On Mar 18, 2018, at 10:53 AM, Bill Johnson <[email protected]> wrote: >> >> Do you have the equalizer set higher levels or lower on the upper audio >> range? >> ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
