Mark,
That indicates you are not getting the right button response.
Check the Front Panel Board. My immediate guess is that you have a
soldering problem on RP1, or that RP1 is inserted backwards. That is one
of the R-Paks that MUST be inserted in the proper orientation. Look at
the board silkscreen for the pin 1 location, and look for the dot at the
end of the R-Pak - they must be aligned.
You could also have a solder splash somewhere on the FP board.
73,
Don W3FPR
On 6/10/2018 5:31 PM, Mark Petrovic wrote:
Don, thanks.
When I exit CAL FIL, and press and hold CW RV, I see "ST P 0.60"
displayed (with the B RIT and XIT annunciators on) whether in CW, USB
or LSB mode.
On Sun, Jun 10, 2018 at 2:21 PM, Don Wilhelm <[email protected]
<mailto:[email protected]>> wrote:
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
