I have the USB connected and am reading the frequency fine. > On Nov 22, 2018, at 2:12 PM, Nr4c <[email protected]> wrote: > > You need some sort of connection between the radio and computer. Simplest is > the USB cable that came with your K3S. Set CONFIG/PTT/KEY to RTS DTR on the > radio of in n1mm+ go to Configure and set the com port (from Win device > manager “ports”) and set the radio and then set KEY and PTT same as you did > the radio. > > Sent from my iPhone > ...nr4c. bill > > >> On Nov 22, 2018, at 11:46 AM, Jim Cary <[email protected]> wrote: >> >> I’m trying to get my K3S and N1MM+ to work on cw without an interface (which >> I have used in the past). I’ve tried a couple of the suggestions I’ve seen >> on the reflector but none of them seem to work. >> >> I’m sure someone has figured out an easy way to do this and would appreciate >> the info. >> >> Thanks, >> >> Jim >> W2SM >> >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> Message delivered to [email protected] >
______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
