Gary,
If you are not afraid of disassembling your K3, remove the Front Panel
assembly and swap the encoder A with encoder B. If the problem follows
the encoder, then order a new encoder from Elecraft. If that is not the
problem, contact [email protected] for additional checks.
73,
Don W3FPR
On 1/26/2020 5:34 PM, Gary K9GS wrote:
I just had my K3 in for service and a checkup. I REALLY hope I can avoid
sending it in again. The VFO B knob is completely dead. Turning it does not
tune VFO B. Also tried the config screen...same thing.I suspect the encoder is
bad but it showed no symptoms prior..otherwise I would have had it changed out
when I sent it in.All other front panel functions appear to work.Any
ideas?73,Gary K9GS
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
