Hi All,I finally found some time this morning to take apart my K3.Removing the front panel was relatively easy. I swapped the VFO A and VFO B encoders and I did have a defective VFO B encoder .I've ordered a replacement encoder from Elecraft, $60 plus shipping. 73,Gary K9GS -------- Original message --------From: Gary K9GS <[email protected]> Date: 1/27/20 9:59 AM (GMT-06:00) To: [email protected] Subject: Re: [Elecraft] VFO B dead Thank you Vic and others.It's been a long time since I assembled my K3. I reviewed the assembly documentation last night. I did not remember that the encoders plug into the PCBA. It looks like a pretty straightforward disassembly and reassembly.Vic asked if the encoder could have come unplugged, possibly in shipping when my K3 was back at Elecraft. I'm not sure how that could happen since the encoder is attached to the front panel with a nut. The nut and the VFO knob would have to both be missing for that to happen. I just wonder if since I have to take the whole front panel off to replace, should I just order replacements?Does anyone know if the encoders can be replaced if I remove the knob and nut without taking the front panel off?If I get some time this week I'll open up the K3 and take a look.73,Gary K9GS-------- Original message --------From: Victor Rosenthal <[email protected]> Date: 1/26/20 11:56 PM (GMT-06:00) To: [email protected], Gary K9GS <[email protected]> Subject: Re: [Elecraft] VFO B dead ...and the first thing to check is that one of them hasn't come unplugged!73,Victor, 4X6GPRehovot, IsraelFormerly K2VCOCWops no. 5http://www.qsl.net/k2vco/On 27/01/2020 6:38, Nr4c wrote: > Download the K3 Assembly Manual. I believe they just plug in. > > Sent from my iPhone > ...nr4c. bill > > >> On Jan 26, 2020, at 10:50 PM, Gary K9GS <[email protected]> wrote: >> >> Hello Don,How difficult is it to replace the encoders? Is there a document that describes the procedure?73,Gary K9GS >> -------- Original message --------From: Don Wilhelm <[email protected]> Date: 1/26/20 8:15 PM (GMT-06:00) To: Gary K9GS <[email protected]>, [email protected] Subject: Re: [Elecraft] VFO B dead Gary,If you are not afraid of disassembling your K3, remove the Front Panel assembly and swap the encoder A with encoder B. If the problem follows the encoder, then order a new encoder from Elecraft. If that is not the problem, contact [email protected] for additional checks.73,Don W3FPR______________________________________________________________Elecraft mailing listHome: http://mailman.qth.net/mailman/listinfo/elecraftHelp: http://mailman.qth.net/mmfaq.htmPost: mailto:[email protected] list hosted by: http://www.qsl.netPlease help support this email list: http://www.qsl.net/donate.htmlMessage delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected]
This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
