The encoder itself, if you want to re-solder it, is Bourns Inc. ENS1D-B28-L00100L
cost is about $58 in DigiKey and $45 in Mouser On Thu, Feb 6, 2020 at 11:57 AM K9MA <[email protected]> wrote: > On 2/6/2020 10:03, Gary K9GS wrote: > > Hi All,I finally found some time this morning to take apart my > K3.Removing the front panel was relatively easy. I swapped the VFO A and > VFO B encoders and I did have a defective VFO B encoder .I've ordered a > replacement encoder from Elecraft, $60 plus shipping. 73,Gary K9GS > > I haven't had any failures, but a while ago I ordered some spare > encoders and pots for my K3, just in case they aren't available in the > future. > > 73, > > Scott K9MA > > -- > Scott K9MA > > [email protected] > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
