If one sets the power correct with the amp in OPER mode, there is no reason to make further power adjustments. The system is just doing as you have instructed it to do.
When the amp is in STBY the power reverts to that for barefoot normally 100 watts or the last value set for that mode. Bob, K4TAX Sent from my iPhone > On Mar 12, 2020, at 2:50 AM, Tony <[email protected]> wrote: > > All: > > I purchased the AUX cable for the K3S / KPA500 to use the per-band power > option so the drive levels would stay put when the amp was in operation. > > After setting the proper drive level for each band, I noticed that the > settings I chose were lost if I turned the power up on the K3S. > > I thought the per-band settings might go back to their presets if I cycled > the KPA500 from operate to standby and back, but that didn't work. > > If the per-band drive levels are easily bypassed, it defeats the whole > purpose of having this option. > > Am I missing something? > > Tony > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
