Don Nesbitt wrote:
Set: 4800, N, 8, 1, DTR = CW, RTS = PTT, Radio/VFO nr =1, Radio PTT Delay =
30, Radio PTT via command block checked
If you decide to use DTR/RTS, be aware that your computer may raise
these lines during bootup. So if you are in CW mode when you boot your
computer, you may unexpectedly transmit a dash or two.
I found the DTR CW to work very well, and I could get rid of the
parallel port interface I was using for computer-generated CW. I don't
use the PTT, just selecting full or semi QSK on the K3.
--
73,
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco
K3 no. 00007
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
