Julian, I set the power by double clicking in the software. I made no changes to the config settings so this was definitely a software created change.
Bill -----Original Message----- Bill Johnson-9 wrote: > > I found the problem. I had used KComm software yesterday. I used the 5 > watt setting and this caused a loss of control over 12 watts on the front > panel dial. The 25 and 100 watt levels work fine. I will post this to > the > general reflector so others will be aware. > > > > Previous message: > > I was operating PSK31 on 14 meters and set power to 10 watts. I used my > Hi Bill. This happens to me sometimes, too. I find that the KPA3 menu setting has been set to Bypass. You have to go into the menu and switch it back to Nor. It's interesting that you associate the problem with using KComm. Did you set the power to 5W by double-clicking the shortcut? Perhaps setting the power level by software command causes the problem? However I quite often set the power to 5W using this shortcut and I certainly do not disable the PA every time. ----- Julian, G4ILO. K2 #392 K3 #222. http://www.g4ilo.com/ G4ILO's Shack http://www.ham-directory.com/ Ham Directory http://www.g4ilo.com/kcomm.html KComm for Elecraft K2 and K3 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
