Julian, Assuming you are using the K22; extended mode, use PC0051; to set 5 Watts (5 Watts, high range). The PC0500; sets to 5.0 Watts in the low range (turns off the PA).
The only downside to using the PC0051; syntax is that you can't set the power to other than integral values of power (2.0, 3.0, 4.0, etc. Watts). 73, ... Joe, W4TV > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Julian, G4ILO > Sent: Friday, October 31, 2008 5:44 PM > To: [email protected] > Subject: RE: [Elecraft] K3 Firmware 2.58 > > > > > > Bill Johnson-9 wrote: > > > > Julian, > > > > Here's what's in the command: PC0500;PC;DS; > > > > I tried it again and I get the same thing. The power cannot be > > adjusted with the front panel dial past 12 watts. > > > > > > Bill > > > You are right. Perhaps someone can advise how to reduce power > to below 12W by software command without disabling the > ability to increase it above that level again using the front > panel control. > > ----- > Julian, G4ILO. K2 #392 K3 #222. > http://www.g4ilo.com/ G4ILO's Shack > http://www.ham-directory.com/ Ham > Directory http://www.g4ilo.com/kcomm.html KComm for > Elecraft K2 and K3 > -- > View this message in context: > http://n2.nabble.com/K3-Firmware-2.58-tp1437773p1438626.html > Sent from the Elecraft mailing list archive at Nabble.com. > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
