Bill Johnson-9 wrote:
>
> Julian,
>
> I set the power by double clicking in the software. I made no changes to
> the config settings so this was definitely a software created change.
>
> Bill
>
>
I have never disabled the PA intentionally from the menu either.
Strange. All the shortcut does is cause the commands: PC0500;PC;DS; to be
sent to the radio. You can right-click it and see the commands that are
sent, and change them if you want to.
The PC0500; sets the power to 5W. The PC; causes the power level to be
reported back to the program straight away and the DS; causes the status
information to be updated.
Only the first command is necessary to set the power. The others are just so
you can see the effect immediately. Nothing that is sent should have the
effect of disabling the PA permanently.
-----
Julian, G4ILO. K2 #392 K3 #222.
http://www.g4ilo.com/ G4ILO's Shack http://www.ham-directory.com/ Ham
Directory http://www.g4ilo.com/kcomm.html KComm for Elecraft K2 and K3
--
View this message in context:
http://n2.nabble.com/K3-Firmware-2.58-tp1437773p1437924.html
Sent from the Elecraft mailing list archive at Nabble.com.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
