I have a strange behaviour on the following Inkscape gcodetools created G-code
the g-code is here
http://pastebin.com/wFYYUJRa
not sure if it is on start or end of arcs
the y axis has a hick-up
ends up that I get a -3mm offset in Y
I use 2.6.3 from tghe last install ISO
I have tested my stepper drivers and machine with
g-code running several axis together results in positioning is OK
Anyone has a hint what I can test to find where the hick-up comes from
Ju
------------------------------------------------------------------------------
Meet PCI DSS 3.0 Compliance Requirements with EventLog Analyzer
Achieve PCI DSS 3.0 Compliant Status with Out-of-the-box PCI DSS Reports
Are you Audit-Ready for PCI DSS 3.0 Compliance? Download White paper
Comply to PCI DSS 3.0 Requirement 10 and 11.5 with EventLog Analyzer
http://pubads.g.doubleclick.net/gampad/clk?id=154622311&iu=/4140/ostg.clktrk
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
