I only took a quick look while a HUGE system recompile is going on...
The one thing I can think of is to add a standard
Put-My-Machine-In-A-Known-State in the header. I typically use
something like:
G40 G17 G20 G90 G61
looks like you will want to change G20=>G21, etc., but make sure that
the program forces the machine into a known state every time. Other
than that I just took a cursory glance. I am sure that others will
chime in and sort out and dependency ;-)
EBo --
On Sep 22 2014 8:03 PM, Juergen Gnoss wrote:
> I have a strange behaviour on the following Inkscape gcodetools
> created G-code
> the g-code is here
> http://pastebin.com/wFYYUJRa
>
> not sure if it is on start or end of arcs
> the y axis has a hick-up
> ends up that I get a -3mm offset in Y
> I use 2.6.3 from tghe last install ISO
>
> I have tested my stepper drivers and machine with
> g-code running several axis together results in positioning is OK
>
> Anyone has a hint what I can test to find where the hick-up comes
> from
>
> Ju
>
>
> ------------------------------------------------------------------------------
> Meet PCI DSS 3.0 Compliance Requirements with EventLog Analyzer
> Achieve PCI DSS 3.0 Compliant Status with Out-of-the-box PCI DSS
> Reports
> Are you Audit-Ready for PCI DSS 3.0 Compliance? Download White paper
> Comply to PCI DSS 3.0 Requirement 10 and 11.5 with EventLog Analyzer
>
> http://pubads.g.doubleclick.net/gampad/clk?id=154622311&iu=/4140/ostg.clktrk
> _______________________________________________
> Emc-developers mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/emc-developers
------------------------------------------------------------------------------
Meet PCI DSS 3.0 Compliance Requirements with EventLog Analyzer
Achieve PCI DSS 3.0 Compliant Status with Out-of-the-box PCI DSS Reports
Are you Audit-Ready for PCI DSS 3.0 Compliance? Download White paper
Comply to PCI DSS 3.0 Requirement 10 and 11.5 with EventLog Analyzer
http://pubads.g.doubleclick.net/gampad/clk?id=154622311&iu=/4140/ostg.clktrk
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
