Gene i cnat show pix of the actual machine and parts ( proprietary) but here's edm using linuxcnc to position ( pose) and hal to cut http://videobin.org/+6cw/786.html ^^^ no need to join here either, regards tomp
On 04/12/2015 10:00 AM, Gene Heskett wrote: > Sometime, you might describe how noisy it is. I tend to rate this stuff > with the 30 db shooting muffs on, as noisy, damned noisy, and ohmygawd > that hurts. ;-) > when i did 450 amp cuts for GE in Winston Salem it was the extreme edge of edm. it sounded like machine gun fire just muffled by being done in a 1 meter deep tank. we were matching two hammer die halves for props. the process just cant be stabilized at that current density. the acceptance requirement was 11cu in/hr. and i did that by tossing the autopilot, putting 1 hand on the loop set point and the other on the flush control. after 1hr, i relaxed. ------------------------------------------------------------------------------ BPM Camp - Free Virtual Workshop May 6th at 10am PDT/1PM EDT Develop your own process in accordance with the BPMN 2 standard Learn Process modeling best practices with Bonita BPM through live exercises http://www.bonitasoft.com/be-part-of-it/events/bpm-camp-virtual- event?utm_ source=Sourceforge_BPM_Camp_5_6_15&utm_medium=email&utm_campaign=VA_SF _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers
