g30 & g30.1? interesting when combines with retract and i see the intermediate point would be easy ( the rufpoint might be an intermediate point from the cone surface towards the startpoint above the workpiece.
i really have to do some drawings :| thx for the reminder about G30 tomp tjtr33 On 04/14/2015 11:04 AM, andy pugh wrote: > On 14 April 2015 at 16:17, Robert Ellenberg <rwe...@gmail.com> wrote: > >> 1) "Retract-to-setpoint-on-abort" modal code. If a retract point is set, >> the machine would automatically retract to that position on abort. Abort >> would also clear this set point. >> >> Perhaps this pair of G codes could work (chosen somewhat arbitrarily): >> G15 X## Y## Z## = set a retract point in local coordinates (and enable >> auto-retract mode). > > I see that this uses relative rather than absolute coordinates, but > does it really do anything that G20 and G30 don't already do? > > For a standalone sink/orbit HAL module this would probably just remove > all offsets then start again. > As I said in my previous reply, I think I see reverse-run of G-code > and sink/orbit as completely separate problems. > ------------------------------------------------------------------------------ BPM Camp - Free Virtual Workshop May 6th at 10am PDT/1PM EDT Develop your own process in accordance with the BPMN 2 standard Learn Process modeling best practices with Bonita BPM through live exercises http://www.bonitasoft.com/be-part-of-it/events/bpm-camp-virtual- event?utm_ source=Sourceforge_BPM_Camp_5_6_15&utm_medium=email&utm_campaign=VA_SF _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers
