Neil, Are you using an off the shelf A20 board, or did you spin your own?
As for your distro, what was your approach? Did you start from scratch / Linux From Source approach, ending up with your development copy being nearly identical to the production copy? OR Did you start with a light / customizable distro like gentoo, which has package management maintained on the dev side. Then you copy a subset of the system to create your production distro? Continuing Jepler's work with the Odroid boards or similar to make a robust embedded controller appliance with LinuxCNC would be excellent to learn. Thank you, -Tom On Tue, Dec 29, 2015 at 3:27 PM, Rick Lair <[email protected]> wrote: > I will have to look further into this, but Fagor Automation, of which we > have two controls in our shop, is based off of a Linux software, and > these are "Embedded", straight to the control, no desktop-ish look and > feel. > > When you power the control on, it says "DECOMPRESSING LINUX", > > > -- > > Thanks > > > Rick Lair > Superior Roll & Turning LLC > 399 East Center Street > Petersburg MI, 49270 > PH: 734-279-1831 > FAX: 734-279-1166 > www.superiorroll.com > > > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-developers mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-developers > ------------------------------------------------------------------------------ _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
