I am probably going to need a couple of weeks before I get back to the DC area and have access to all my stuff. Can we postpone ramping up the Gentoo thread until then? If you want to start before hand I do have a Gentoo laptop with me, but I have other obligations for the holidays that will keep me from doing to many extracurricular activities...
EBo -- On Dec 30 2015 2:12 PM, Thomas Gambone II wrote: > Thank you for the offer to support, EBo! > > With gentoo, I've gotten into it on the Odroid C1, though not too > successfully. > Can't figure out some quirkiness with slow booting that happens. > > May be worth staring another thread to discuss. > > Will revisit my unfinished attempt and loop back. > > Thank you, > -Tom > > On Wed, Dec 30, 2015 at 3:23 PM, EBo <[email protected]> wrote: > >> If you end up working/developing on Gentoo, I will make time to lend >> a >> hand on that (or as much time as I can). >> >> EBo -- >> >> On Dec 30 2015 11:56 AM, Thomas Gambone II wrote: >> > Neil, >> > >> > Are you using an off the shelf A20 board, or did you spin your >> own? >> > >> > As for your distro, what was your approach? >> > >> > Did you start from scratch / Linux From Source approach, >> > ending up with your development copy being nearly identical to the >> > production copy? >> > >> > OR >> > >> > Did you start with a light / customizable distro like gentoo, >> which >> > has >> > package management maintained on the dev side. >> > Then you copy a subset of the system to create your production >> > distro? >> > >> > Continuing Jepler's work with the Odroid boards or similar to make >> a >> > robust >> > embedded controller appliance with LinuxCNC would be excellent to >> > learn. >> > >> > Thank you, >> > -Tom >> > >> > >> > On Tue, Dec 29, 2015 at 3:27 PM, Rick Lair <[email protected]> >> > wrote: >> > >> >> I will have to look further into this, but Fagor Automation, of >> >> which we >> >> have two controls in our shop, is based off of a Linux software, >> and >> >> these are "Embedded", straight to the control, no desktop-ish >> look >> >> and >> >> feel. >> >> >> >> When you power the control on, it says "DECOMPRESSING LINUX", >> >> >> >> >> >> -- >> >> >> >> Thanks >> >> >> >> >> >> Rick Lair >> >> Superior Roll & Turning LLC >> >> 399 East Center Street >> >> Petersburg MI, 49270 >> >> PH: 734-279-1831 >> >> FAX: 734-279-1166 >> >> www.superiorroll.com >> >> >> >> >> >> >> >> >> >> >> >> ------------------------------------------------------------------------------ >> >> _______________________________________________ >> >> Emc-developers mailing list >> >> [email protected] >> >> https://lists.sourceforge.net/lists/listinfo/emc-developers >> >> >> > >> > >> >> ------------------------------------------------------------------------------ >> > _______________________________________________ >> > Emc-developers mailing list >> > [email protected] >> > https://lists.sourceforge.net/lists/listinfo/emc-developers >> >> >> >> >> ------------------------------------------------------------------------------ >> _______________________________________________ >> Emc-developers mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-developers >> > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-developers mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-developers ------------------------------------------------------------------------------ _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
