Thank you for the offer to support, EBo! With gentoo, I've gotten into it on the Odroid C1, though not too successfully. Can't figure out some quirkiness with slow booting that happens.
May be worth staring another thread to discuss. Will revisit my unfinished attempt and loop back. Thank you, -Tom On Wed, Dec 30, 2015 at 3:23 PM, EBo <[email protected]> wrote: > If you end up working/developing on Gentoo, I will make time to lend a > hand on that (or as much time as I can). > > EBo -- > > On Dec 30 2015 11:56 AM, Thomas Gambone II wrote: > > Neil, > > > > Are you using an off the shelf A20 board, or did you spin your own? > > > > As for your distro, what was your approach? > > > > Did you start from scratch / Linux From Source approach, > > ending up with your development copy being nearly identical to the > > production copy? > > > > OR > > > > Did you start with a light / customizable distro like gentoo, which > > has > > package management maintained on the dev side. > > Then you copy a subset of the system to create your production > > distro? > > > > Continuing Jepler's work with the Odroid boards or similar to make a > > robust > > embedded controller appliance with LinuxCNC would be excellent to > > learn. > > > > Thank you, > > -Tom > > > > > > On Tue, Dec 29, 2015 at 3:27 PM, Rick Lair <[email protected]> > > wrote: > > > >> I will have to look further into this, but Fagor Automation, of > >> which we > >> have two controls in our shop, is based off of a Linux software, and > >> these are "Embedded", straight to the control, no desktop-ish look > >> and > >> feel. > >> > >> When you power the control on, it says "DECOMPRESSING LINUX", > >> > >> > >> -- > >> > >> Thanks > >> > >> > >> Rick Lair > >> Superior Roll & Turning LLC > >> 399 East Center Street > >> Petersburg MI, 49270 > >> PH: 734-279-1831 > >> FAX: 734-279-1166 > >> www.superiorroll.com > >> > >> > >> > >> > >> > ------------------------------------------------------------------------------ > >> _______________________________________________ > >> Emc-developers mailing list > >> [email protected] > >> https://lists.sourceforge.net/lists/listinfo/emc-developers > >> > > > > > ------------------------------------------------------------------------------ > > _______________________________________________ > > Emc-developers mailing list > > [email protected] > > https://lists.sourceforge.net/lists/listinfo/emc-developers > > > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-developers mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-developers > ------------------------------------------------------------------------------ _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
