Hello Joe,

What is the reference for the markings? Depending on the standard used for a
mains plug you may be required to mark the terminals "L" and/or "N" on the
plug. However, this usually applies to rewireable mains plugs and not molded
ones. 

Regards,
+=================================================================+
|Ronald R. Wellman                |Voice : 408-345-8229           |
|Agilent Technologies             |FAX   : 408-345-8630           |
|5301 Stevens Creek Blvd.,        |E-Mail: [email protected]|
|Mailstop 51L-SQ                  |WWW   : http://www.agilent.com |
|Santa Clara, California 95052 USA|                               |
+=================================================================+
| "Common sense is the collection of prejudices acquired by age   |
|  eighteen." - Albert Einstein                                   |
+=================================================================+


-----Original Message-----
From: [email protected] [mailto:[email protected]]
Sent: Wednesday, June 14, 2000 8:31 AM
To: [email protected]
Subject: CE Markings for A.C. Mains



Hi Group,

Does anyone know the clause or statement that identifies "L"  for Line
voltage and "N" for Neutral A.C. mains marking in the LVD or any EU standard
published?  I need to provide proof for our engineering team.

Thank you in advance for your help.

Joe 

Josiah P.Burch
Compliance Engineer II
Andover Controls Corporation
300 Brickstone Square
Andover,MA  01810
(978)-470-0555 x335
(978)-470-3615  FAX


-------------------------------------------
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.

To cancel your subscription, send mail to:
     [email protected]
with the single line:
     unsubscribe emc-pstc

For help, send mail to the list administrators:
     Jim Bacher:              [email protected]
     Michael Garretson:        [email protected]

For policy questions, send mail to:
     Richard Nute:           [email protected]


-------------------------------------------
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.

To cancel your subscription, send mail to:
     [email protected]
with the single line:
     unsubscribe emc-pstc

For help, send mail to the list administrators:
     Jim Bacher:              [email protected]
     Michael Garretson:        [email protected]

For policy questions, send mail to:
     Richard Nute:           [email protected]

Reply via email to