Has anyone encountered problems in the use of "pre-plated" sheet steel in IT equipment metalwork ? Typically such material is cheaper to use than having to plate parts after they have been produced, but there may be issues with sharp edges produced when the material is punched out, and with rust on the edges which are not protected.
Regards, John Crabb, Development Excellence (Product Safety) , NCR Financial Solutions Group Ltd., Discovery Centre, 3 Fulton Road, Dundee, Scotland, DD2 4SW E-Mail :[email protected] Tel: +44 (0)1382-592289 (direct ). Fax +44 (0)1382-622243. ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] All emc-pstc postings are archived and searchable on the web at: http://ieeepstc.mindcruiser.com/ Click on "browse" and then "emc-pstc mailing list"
