I've been known to run with scissors (or at least walk briskly) :) Regards, Kaz
From: [email protected] [mailto:[email protected]] On Behalf Of [email protected] Sent: Thursday, May 06, 2004 12:59 PM To: [email protected]; [email protected] Subject: Re:Mutineer A friend of mine did that to be able to plug his TV set into one of those very old two pin receptacles that doesn't have the one larger polarizing slot. After a few months of very high electric bills he investigated and found that his TV set plug was in backwards causing the chassis ground to be HOT including the coax line to his TV antenna. He obviously didn't have his antenna grounded but there must have been enough leakage current to drive his electric bill up. Do you also wire things around your house without turning off the breaker? I do that. I wonder what other crazy things safety engineers are doing out there like cutting the ground tab off the plug of their microwave. (Every time my wife revs up the microwave I wet my pants and forget who I am for half an hour.) Brian ____________________Reply Separator____________________ Subject: Mutineer Author: [email protected] List-Post: [email protected] Date: 5/06/04 12:35 PM I consider myself a responsible, conscientious product safety engineer. I wish to publicly announce that I grind off the polarizing ears on the pins of all my US two pin power plugs. So THERE. :^) Bob Johnson This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ieee-pses.org/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ieee-pses.org/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ieee-pses.org/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc
