Interesting N-hexane is also the gas they inject into test chambers to see if 
there is an explosion in the presence of a spark. 
Mil-810F section 511.4-2 
paragraph 2.1 
Unless otherwise specific, use n-hexane, either reagent grade or 95% n-hexane 
with 5% hexane isomers. 
Given that the test explosion in the chamber was much less impressive than I 
had hoped for the sheer test excitement value, it must be a very low ignition 
point, low energy fuel. No wonder my labels never stick on, they are getting 
blown off in shipping.

Gary


-----Original Message-----
From: John Woodgate [mailto:[email protected]] 
Sent: Tuesday, March 26, 2013 1:24 PM
To: [email protected]
Subject: Re: [PSES] 60950-1 durability test solvent

In message <C2866F9FC4CB034EB51A633DF16859860CEA7518@ssbarcelone>, dated 
Tue, 26 Mar 2013, "Gelfand, David" <[email protected]> 
writes:

>Is there a product I can buy at the hardware store that is roughly 
>equivalent to the hexane specified in durability test:
>
>" The petroleum spirit to be used for the test is aliphatic solvent 
>hexane having a maximum aromatics content of 0,1 % by volume, a 
>kauributenol value of 29, an initial boiling point of approximately 65 
>°C, a dry point of approximately 69 °C and a mass per unit volume of 
>approximately 0,7 kg/l."

It's actually about 20% nonsense.  I'll explain. Long years ago, I 
objected to the bare phrase 'petroleum spirit' in IEC 65 (as it was 
then, because people were using all sorts of jungle juice, some of which 
dissolved the moulded enclosures. I suggested defining the reagent as 
'n-hexane'. The convener at that time, not being a chemist, asked a 
company chemist what 'n-hexane' was, and received that complicated text, 
presumably extracted from a supplier's specification.

Later, I raised the issue again, following complaints that reagent to 
that specification was no longer available except as a 'to order' 
product, and that text was meant to be replaced by a simpler one, but I 
see in current (and even future) editions (of IEC/EN 60065, I haven't 
looked at IEC/EN 60950-1 or 62389-1 in case they are even more 
disappointing), the text is in the wrong order, or the GOOD information 
is relegated to a Note:

NOTE The designation “n-hexane” is chemical nomenclature for a 
"normal" or straight chain hydrocarbon. This petroleum spirit may 
further be identified as a certified ACS (American Chemical Society) 
reagent grade hexane 1042 (CAS# 110-54-3).

You should be able to buy that quite easily.
-- 
OOO - Own Opinions Only. See www.jmwa.demon.co.uk
SHOCK HORROR! Dinosaur-like DNA found in chicken and turkey meals
John Woodgate, J M Woodgate and Associates, Rayleigh, Essex UK

-
----------------------------------------------------------------
This message is from the IEEE Product Safety Engineering Society emc-pstc 
discussion list. To post a message to the list, send your e-mail to 
<[email protected]>

All emc-pstc postings are archived and searchable on the web at:
http://www.ieee-pses.org/emc-pstc.html

Attachments are not permitted but the IEEE PSES Online Communities site at 
http://product-compliance.oc.ieee.org/ can be used for graphics (in well-used 
formats), large files, etc.

Website:  http://www.ieee-pses.org/
Instructions:  http://listserv.ieee.org/request/user-guide.html
List rules: http://www.ieee-pses.org/listrules.html

For help, send mail to the list administrators:
Scott Douglas <[email protected]>
Mike Cantwell <[email protected]>

For policy questions, send mail to:
Jim Bacher:  <[email protected]>
David Heald: <[email protected]>

-
----------------------------------------------------------------
This message is from the IEEE Product Safety Engineering Society emc-pstc 
discussion list. To post a message to the list, send your e-mail to 
<[email protected]>

All emc-pstc postings are archived and searchable on the web at:
http://www.ieee-pses.org/emc-pstc.html

Attachments are not permitted but the IEEE PSES Online Communities site at 
http://product-compliance.oc.ieee.org/ can be used for graphics (in well-used 
formats), large files, etc.

Website:  http://www.ieee-pses.org/
Instructions:  http://listserv.ieee.org/request/user-guide.html
List rules: http://www.ieee-pses.org/listrules.html

For help, send mail to the list administrators:
Scott Douglas <[email protected]>
Mike Cantwell <[email protected]>

For policy questions, send mail to:
Jim Bacher:  <[email protected]>
David Heald: <[email protected]>

Reply via email to