I can live with that. Chris Radek wrote: > On Sun, Aug 05, 2007 at 09:06:44AM -0400, Dale wrote: > >>No, if no axis words specified then G28 is invalid input and no axis >>should move. > > > My understanding is a bare G28 is allowed in HAAS. In Fanuc programs, > since it's an error, nobody would write it, so its behavior in EMC > doesn't matter. In historical EMC, bare G28 was allowed and it still > is, and gives the same behavior, so those programs don't break. > > My thinking is that it's OK to give fewer errors than other controls > if the behavior is useful and increases compatibility. This (bare > G28) is definitely one of those cases. > > Chris > > ------------------------------------------------------------------------- > This SF.net email is sponsored by: Splunk Inc. > Still grepping through log files to find problems? Stop. > Now Search log events and configuration files using AJAX and a browser. > Download your FREE copy of Splunk now >> http://get.splunk.com/ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users >
------------------------------------------------------------------------- This SF.net email is sponsored by: Splunk Inc. Still grepping through log files to find problems? Stop. Now Search log events and configuration files using AJAX and a browser. Download your FREE copy of Splunk now >> http://get.splunk.com/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
