Aram, Looking closer at that link those are only the flange mounts. The bearings are not included. For a .311" shaft end they are also recommending 2 deep groove ball bearings and not angular contact bearings.
Chris [EMAIL PROTECTED] wrote: > Hi > Hi > > I found something close > > First end of lead screw= need have > http://www.nookindustries.com/endmount/EndMountsFlange.cfm#Capacity > To hold against trust load from the lead screw. > Flange-Mount double is OK. > Second end of lead screw need to have simple flat to connect it with > coupling to the shaft of servomotor. > Coupling need have two set screws. > Diameter of motor shaft 0.866 inch. > What do you think? > Will it work? > > Thank you, > Aram > > > > ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
