On Mon, Jul 07, 2008 at 04:30:38PM -0400, Eric H. Johnson wrote: > Hi, > > I am trying to update a configuration which runs correctly under EMC 2.2.0 > to the current stable 2.2.5, and am getting an error message I do not > understand. > > The error message points to line 19 in vti_motion.hal and states: > "error in setp, 2 parameters expected but 3 were found". > > Line 19 of vti_motion.hal reads: > setp vti.0.position-scale [AXIS_0]INPUT_SCALE
http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?UPDATING#setp_requires_2_arguments_3_given I wonder if you were actually running 2.1.x before...? This UPDATING page is always the place to check for necessary config changes. Chris ------------------------------------------------------------------------- Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW! Studies have shown that voting for your favorite open source project, along with a healthy diet, reduces your potential for chronic lameness and boredom. Vote Now at http://www.sourceforge.net/community/cca08 _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
