Eric H. Johnson wrote:
> The dir signal appears to be working properly as well. If .value is 0 or
> positive, pin 19 is low, if .value is negative then pin 19 is high.
> 
> As for the PWM, I am measuring it with a meter, not a scope, but it does not
> change (the voltage measured will typically be proportional to duty cycle).
> In addition, if I load the standard m5i20 configuration, I do get the
> appropriate values on pin 15.

Well that's very odd...

Try loading the hostmot2 driver will all debugging enabled:

     loadrt hostmot2 debug_idrom=1 debug_module_descriptors=1 
debug_pin_descriptors=1 debug_modules=1

Then pastebin the dmesg output and mail us the link.

I'll hop on irc, come chat there if you want.


-- 
Sebastian Kuzminsky
       Theo: "Julian? I haven't seen you in twenty years. You look good.
              The picture the police have of you doesn't do you justice."
     Julian: "What do the police know about justice?"

-------------------------------------------------------------------------
This SF.Net email is sponsored by the Moblin Your Move Developer's challenge
Build the coolest Linux based applications with Moblin SDK & win great prizes
Grand prize is a trip for two to an Open Source event anywhere in the world
http://moblin-contest.org/redirect.php?banner_id=100&url=/
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to