>
> I presumed the selecting of one PWM in the configuration set the direction
> of the GPIO, as it does for the step and direction outputs for the two
> steppers in the configuration.
>
> Regards,
> Eric
>
It should...

Is the PWM pin high or low?

Did you start with Sebastians HAL file? I know he has PWM running his servo 
motors.


The only other setup type thing that I can think of is that the master PWM 
rate DDS must be setup, Dont know if the driver gives access to this yet (PWM 
rate) but if this is not written the PWM rate will be 0 Hz...

There are also several PWM mode setup bits, but my guess is the driver leaves 
them at the default = normal PWM


>

Peter Wallace
Mesa Electronics

(\__/)
(='.'=) This is Bunny. Copy and paste bunny into your
(")_(") signature to help him gain world domination.


-------------------------------------------------------------------------
This SF.Net email is sponsored by the Moblin Your Move Developer's challenge
Build the coolest Linux based applications with Moblin SDK & win great prizes
Grand prize is a trip for two to an Open Source event anywhere in the world
http://moblin-contest.org/redirect.php?banner_id=100&url=/
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to