Sebastian Kuzminsky wrote:
> The pwmgen.XX.enable HAL pin gets initialized to 0 and sent to the FPGA 
> on module load.  When the user changes the HAL pin, the new value is 
> sent to the FPGA.  Eric, can you verify that the HAL enable pin for the 
> PWM in question does get set to 1?

Another thing to check is: are you setting pwmgen.00.scale?

When you set the pwmgen's "value" pin, it gets turned into a pwm duty 
cycle by this formula: duty_cycle = value/scale (clipped so duty cycle 
stays within the -1.0 to +1.0 range).  So a simple way to test it is to 
leave the scale parameter at the default (1.0), then "setp value" to 
values between -1 and +1 to try to drive the pwm outputs.


-- 
Sebastian Kuzminsky
"Much of what we learned from the sense of touch was unscientific
prejudice, which must be rejected if we are to have a true picture
of the world."  -- Bertrand Russell

-------------------------------------------------------------------------
This SF.Net email is sponsored by the Moblin Your Move Developer's challenge
Build the coolest Linux based applications with Moblin SDK & win great prizes
Grand prize is a trip for two to an Open Source event anywhere in the world
http://moblin-contest.org/redirect.php?banner_id=100&url=/
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to