On Sat, Oct 25, 2008 at 02:51:19PM -0700, richard harris wrote:
> 
> I am currently running emc 2.2.6   I
> have been threading a right hand M10x1.25 thread all day
> approximately 90 parts.  I switched to cutting a left hand M10x1.25
> and everything was fine for the first 20 parts then suddenly on the
> spring back pass it will rapid one of the cuts.  I looked at the
> wires on the spindle encoder to see if anything got loose and all
> looked fine.  Ran the same code again with no problems, thought it
> was a fluke and continued to run parts.  Four parts later it did the
> same rapid still on a spring pass but the last one not the first. 
> Ran the program ten times in the air and 4 times it ran perfectly 6
> times it rapided in a spring pass, always a spring pass.  I switched
> back to right hand cuts and it ran without issue.  

What is your spindle encoder hooked to?  Jon E and I saw this behavior
on some PPMC boards but it is long fixed as far as I know.

If you can capture the encoder count and index-enable on halscope
when this happens, it would "tell all".

Are you using G76?  Like John K asked, are you using M3 or M4?


-------------------------------------------------------------------------
This SF.Net email is sponsored by the Moblin Your Move Developer's challenge
Build the coolest Linux based applications with Moblin SDK & win great prizes
Grand prize is a trip for two to an Open Source event anywhere in the world
http://moblin-contest.org/redirect.php?banner_id=100&url=/
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to