Thanks all for your usefull information . I could solve the problem and it was setting in BIOS , and now the machine work perfect .
Regards Parviz -----Original Message----- From: andy pugh [mailto:[email protected]] Sent: Monday, June 25, 2012 2:49 PM To: Enhanced Machine Controller (EMC) Subject: Re: [Emc-users] FW: Sherline Mill 5410 and EMC2 On 25 June 2012 04:57, Robot Abzar Team <[email protected]> wrote: > 2- yes I tested the Axis but they didn't move in this test !! This probably indicates that the drives are not being enabled. Have you connected any amp-enable pins? > 3- I woud like the parallel port signal but I don't know how I could test it Have a look at: http://wiki.linuxcnc.org/cgi-bin/wiki.pl?Parallel_Port_Tester -- atp If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ---------------------------------------------------------------------------- -- Live Security Virtual Conference Exclusive live event will cover all the ways today's security and threat landscape has changed and how IT managers can respond. Discussions will include endpoint security, mobile security and the latest in malware threats. http://www.accelacomm.com/jaw/sfrnl04242012/114/50122263/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Live Security Virtual Conference Exclusive live event will cover all the ways today's security and threat landscape has changed and how IT managers can respond. Discussions will include endpoint security, mobile security and the latest in malware threats. http://www.accelacomm.com/jaw/sfrnl04242012/114/50122263/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
