Hi , I could solve the problem , it was not about software or hardware , just I have to change something in BIOS . Now machine work nice and perfect .
Regards Parviz -----Original Message----- From: John Stewart [mailto:[email protected]] Sent: Monday, June 25, 2012 4:02 PM To: Enhanced Machine Controller (EMC) Subject: Re: [Emc-users] FW: Sherline Mill 5410 and EMC2 Hi Parviz; As a fairly new Linux-EMC user; I can understand the steep learning curve. A simple question or two:, is there an emergency stop signal turned on? Do the stepper motors get harder to turn when you think the machine is ready to go? > This probably indicates that the drives are not being enabled. Have > you connected any amp-enable pins? > >> 3- I woud like the parallel port signal but I don't know how I could test it > > Have a look at: > http://wiki.linuxcnc.org/cgi-bin/wiki.pl?Parallel_Port_Tester I have found this to be really a great little utility. I added another parallel port, for a "mpg pendant", and this little program made it so much easier. Keep at it; you'll most likely have one of those "slap your forehead" moments when you realize how obvious the error is! (I always seem to get tripped up by the simple things that are obvious in hindsight) JohnS. ---------------------------------------------------------------------------- -- Live Security Virtual Conference Exclusive live event will cover all the ways today's security and threat landscape has changed and how IT managers can respond. Discussions will include endpoint security, mobile security and the latest in malware threats. http://www.accelacomm.com/jaw/sfrnl04242012/114/50122263/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Live Security Virtual Conference Exclusive live event will cover all the ways today's security and threat landscape has changed and how IT managers can respond. Discussions will include endpoint security, mobile security and the latest in malware threats. http://www.accelacomm.com/jaw/sfrnl04242012/114/50122263/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
