I'm adding a PYVCP button to set the G55 offsets and then putting a G55 at the beginning of the gcode file and a G54 at the end.
I think that will work. Thanks, Dave On 10/11/2014 4:23 AM, Viesturs Lācis wrote: > 2014-10-11 6:20 GMT+03:00 Dave Cole <linuxcncro...@gmail.com>: >> Not as easy >> as jogging to the corner of the sheet to cut and pressing the "play" >> button but this should work. > Just jog up to corner and run the file? How do you apply the G92 > offsets then? Are there some commands in beginning of g-code file? If > yes, then why can't you replace those commands with: > G55 > G10 L20 P2 X0 Y0 > or something similar? > > Or add vcp button that would do this? I am sure that there must be > something that sets those G92 offsets, so just replace that. > > > Viesturs > > ------------------------------------------------------------------------------ > Meet PCI DSS 3.0 Compliance Requirements with EventLog Analyzer > Achieve PCI DSS 3.0 Compliant Status with Out-of-the-box PCI DSS Reports > Are you Audit-Ready for PCI DSS 3.0 Compliance? Download White paper > Comply to PCI DSS 3.0 Requirement 10 and 11.5 with EventLog Analyzer > http://p.sf.net/sfu/Zoho > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users --- This email is free from viruses and malware because avast! Antivirus protection is active. http://www.avast.com ------------------------------------------------------------------------------ Meet PCI DSS 3.0 Compliance Requirements with EventLog Analyzer Achieve PCI DSS 3.0 Compliant Status with Out-of-the-box PCI DSS Reports Are you Audit-Ready for PCI DSS 3.0 Compliance? Download White paper Comply to PCI DSS 3.0 Requirement 10 and 11.5 with EventLog Analyzer http://p.sf.net/sfu/Zoho _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
