On 10/10/2014 08:18 AM, Dave Cole wrote: > > I was trying to use a G92 offset to jog to the start position, set a new > zero point, and then start the cut at the corner of the material. > > When the program is stopped midcycle, I'd like to reuse the G92 offsets > so I can start the program again at the same start point. > > But the action of stopping the program seems to be screwing with the G92 > offsets. Even though they are still shown on the screen, they > are no longer active. > > It is something that was put into EMC before 2002, I think, at the urging of Rah Henry. I never liked this "feature", where the G92 offsets are cleared whenever you hit an M02 or abort. One of the great features of Axis is that it stores your G92 offset when you use the touchoff button, and then restores that offset any time it gets cleared.
I think this may not work if you enter the G92 offset in MDI mode. Try doing it with touchoff and see if the behavior changes (assuming you are using Axis.) Jon ------------------------------------------------------------------------------ Meet PCI DSS 3.0 Compliance Requirements with EventLog Analyzer Achieve PCI DSS 3.0 Compliant Status with Out-of-the-box PCI DSS Reports Are you Audit-Ready for PCI DSS 3.0 Compliance? Download White paper Comply to PCI DSS 3.0 Requirement 10 and 11.5 with EventLog Analyzer http://p.sf.net/sfu/Zoho _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
