There is an axis for the second robot and the hal files are all set up. This is about the python interface and running two separate motion commands at the same time. If I can do that, then a simple threading system works, otherwise it needs to be fancier...
jerry On Thu, Sep 24, 2015 at 10:47 AM, Karlsson & Wang < [email protected]> wrote: > > ... > > I now need to extend it to run two separate robots off the same linuxcnc > > controller and receiver program. This brought up a question about the > > python interface. > > Add an extra axis ? > > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > -- Jerry Scharf FINsix IT 650.285.6361 w 650.279.7017 m ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
