have you looked at probe_screen , it's all their
On 14 December 2015 at 12:02, John Thornton <[email protected]> wrote: > With a probe on the way and after viewing a few probe screens which seem > to all be way to complicated for the job it made me wonder what > practical probing routines people would actually use on a mill to > machine parts with. I came up with a few but having never probed a part > I'm looking for input from those that have probes now. > > Measuring a part. > Measure a hole. > Measure a pocket. > > Re-Machining > Locate a hole. > > Setup > Find the top of material. > Check that the vise is square. > Center the probe stylus. > > JT > > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > -- The information contained in this message is confidential and is intended for the addressee only. If you have received this message in error or there are any problems please notify the originator immediately. The unauthorised use, disclosure, copying or alteration of this message is strictly forbidden. This mail and any attachments have been scanned for viruses prior to leaving the RcTechnix network. RcTechnix will not be liable for direct, special, indirect or consequential damages arising from alteration of the contents of this message by a third party or as a result of any virus being passed on. RcTechnix reserves the right to monitor and record e-mail messages being sent to and from this address for the purposes of investigating or detecting any unauthorised use of its system and ensuring effective operation. (c) RcTechnix ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
