Yes, I attempted to get it to work but failed to do so and yes way to complicated with all the .axisrc additions. I also was annoyed by the size of it, every time I go to that tab half is not there so you have to make the screen bigger... it was late last night when I tried. All the cool graphics on the buttons is very pretty but the settings are hard to interpret unless you hover the mouse over each one. And then there is the metric thing lol...
JT On 12/14/2015 6:14 AM, andy pugh wrote: > On 14 December 2015 at 12:02, John Thornton <[email protected]> wrote: >> With a probe on the way and after viewing a few probe screens which seem >> to all be way to complicated for the job it made me wonder what >> practical probing routines people would actually use on a mill to >> machine parts with. > I have the probe-hole.ngc file from the sample folder set up as a > macro in Touchy, and type G38,2 the rest of the time. > > However, I fully intend to install the probe-tab from Verser > https://forum.linuxcnc.org/forum/49-basic-configuration/29187-work-with-probe?limitstart=0 > > Which may well do too much, but why would that be a problem? > > I have actually installed it in my hobbing config, and it was very > little trouble. Though there is no scope for probing at all with my > hobbing setup, it was just a trial. > ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
