send cradeks probe stuff , not seen them they may be better
On 14 December 2015 at 13:03, John Thornton <[email protected]> wrote: > Just looking at the probe routines in the samples and I find a couple of > surface mapping routines and a subroutine probe-hole.ngc with no > comments so not sure what it does. Tom just shared Cradek's probe > routines so I'll look at them for a bit. > > JT > > On 12/14/2015 6:41 AM, Sarah Armstrong wrote: > > it looks as if it's the same package you have looked at . done by the > guys > > over on the russian site > > theirs some probe stuff in the ngc folder . > > > > i have some too that might help , i'll dig them and emails shortly all > > being well > > > > On 14 December 2015 at 12:32, John Thornton <[email protected]> wrote: > > > >> Crumb, I hit delete on your reply and it does not show up in the trash > >> folder... which probe screen are you talking about? > >> > >> JT > >> > >> On 12/14/2015 6:02 AM, John Thornton wrote: > >>> With a probe on the way and after viewing a few probe screens which > seem > >>> to all be way to complicated for the job it made me wonder what > >>> practical probing routines people would actually use on a mill to > >>> machine parts with. I came up with a few but having never probed a part > >>> I'm looking for input from those that have probes now. > >>> > >>> Measuring a part. > >>> Measure a hole. > >>> Measure a pocket. > >>> > >>> Re-Machining > >>> Locate a hole. > >>> > >>> Setup > >>> Find the top of material. > >>> Check that the vise is square. > >>> Center the probe stylus. > >>> > >>> JT > >>> > >>> > >> > ------------------------------------------------------------------------------ > >>> _______________________________________________ > >>> Emc-users mailing list > >>> [email protected] > >>> https://lists.sourceforge.net/lists/listinfo/emc-users > >> > >> > >> > ------------------------------------------------------------------------------ > >> _______________________________________________ > >> Emc-users mailing list > >> [email protected] > >> https://lists.sourceforge.net/lists/listinfo/emc-users > >> > > > > > > > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > -- The information contained in this message is confidential and is intended for the addressee only. If you have received this message in error or there are any problems please notify the originator immediately. The unauthorised use, disclosure, copying or alteration of this message is strictly forbidden. This mail and any attachments have been scanned for viruses prior to leaving the RcTechnix network. RcTechnix will not be liable for direct, special, indirect or consequential damages arising from alteration of the contents of this message by a third party or as a result of any virus being passed on. RcTechnix reserves the right to monitor and record e-mail messages being sent to and from this address for the purposes of investigating or detecting any unauthorised use of its system and ensuring effective operation. (c) RcTechnix ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
