On 14 December 2015 at 12:02, John Thornton <[email protected]> wrote: > With a probe on the way and after viewing a few probe screens which seem > to all be way to complicated for the job it made me wonder what > practical probing routines people would actually use on a mill to > machine parts with.
I have the probe-hole.ngc file from the sample folder set up as a macro in Touchy, and type G38,2 the rest of the time. However, I fully intend to install the probe-tab from Verser https://forum.linuxcnc.org/forum/49-basic-configuration/29187-work-with-probe?limitstart=0 Which may well do too much, but why would that be a problem? I have actually installed it in my hobbing config, and it was very little trouble. Though there is no scope for probing at all with my hobbing setup, it was just a trial. -- atp If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
