I am using the same slow speed (2500mm/min) on both. I set F2500 and I set the jog speed at 2500 with the slider. I am using Gmoccapy
------ Original Message ------ From: "andy pugh" <bodge...@gmail.com> To: "Marius Liebenberg" <mar...@mastercut.co.za>; "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net> Sent: 2016-01-12 13:58:27 Subject: Re: [Emc-users] Very strange behaviour >On 12 January 2016 at 11:39, Marius Liebenberg <mar...@mastercut.co.za> >wrote: > >> I have a machine that I am busy doing the calibration on. I found >>that >> when I use a G1y2000 it would travel the full distance but if I use a >> G0y2000 it only goes 64% of the way. G0Y0 will bring it back to zero. >>It >> is repeatable. > >What happens if you turn down the rapid over-ride to G1 speeds? > >-- >atp >If you can't fix it, you don't own it. >http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ Site24x7 APM Insight: Get Deep Visibility into Application Performance APM + Mobile APM + RUM: Monitor 3 App instances at just $35/Month Monitor end-to-end web transactions and take corrective actions now Troubleshoot faster and improve end-user experience. Signup Now! http://pubads.g.doubleclick.net/gampad/clk?id=267308311&iu=/4140 _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
