It comes to mind that you might try using exact path following, G61? On 01/12/2016 04:01 AM, Marius Liebenberg wrote: > I am using the same slow speed (2500mm/min) on both. I set F2500 and I > set the jog speed at 2500 with the slider. > I am using Gmoccapy > > > ------ Original Message ------ > From: "andy pugh" <bodge...@gmail.com> > To: "Marius Liebenberg" <mar...@mastercut.co.za>; "Enhanced Machine > Controller (EMC)" <emc-users@lists.sourceforge.net> > Sent: 2016-01-12 13:58:27 > Subject: Re: [Emc-users] Very strange behaviour > >> On 12 January 2016 at 11:39, Marius Liebenberg <mar...@mastercut.co.za> >> wrote: >> >>> I have a machine that I am busy doing the calibration on. I found >>> that >>> when I use a G1y2000 it would travel the full distance but if I use a >>> G0y2000 it only goes 64% of the way. G0Y0 will bring it back to zero. >>> It >>> is repeatable. >> >> What happens if you turn down the rapid over-ride to G1 speeds?
... -- Kirk Wallace http://www.wallacecompany.com/machine_shop/ http://www.wallacecompany.com/E45/ ------------------------------------------------------------------------------ Site24x7 APM Insight: Get Deep Visibility into Application Performance APM + Mobile APM + RUM: Monitor 3 App instances at just $35/Month Monitor end-to-end web transactions and take corrective actions now Troubleshoot faster and improve end-user experience. Signup Now! http://pubads.g.doubleclick.net/gampad/clk?id=267308311&iu=/4140 _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
