Just for info sake. It was the micro stepping that was to high. Why it was only evident with G0 is still a mystery to me.
>It comes to mind that you might try using exact path following, G61? > >On 01/12/2016 04:01 AM, Marius Liebenberg wrote: >> I am using the same slow speed (2500mm/min) on both. I set F2500 and >>I >> set the jog speed at 2500 with the slider. >> I am using Gmoccapy >> >> >> ------ Original Message ------ >> From: "andy pugh" <bodge...@gmail.com> >> To: "Marius Liebenberg" <mar...@mastercut.co.za>; "Enhanced Machine >> Controller (EMC)" <emc-users@lists.sourceforge.net> >> Sent: 2016-01-12 13:58:27 >> Subject: Re: [Emc-users] Very strange behaviour >> >>> On 12 January 2016 at 11:39, Marius Liebenberg >>><mar...@mastercut.co.za> >>> wrote: >>> >>>> I have a machine that I am busy doing the calibration on. I found >>>> that >>>> when I use a G1y2000 it would travel the full distance but if I >>>>use a >>>> G0y2000 it only goes 64% of the way. G0Y0 will bring it back to >>>>zero. >>>> It >>>> is repeatable. >>> >>> What happens if you turn down the rapid over-ride to G1 speeds? > >... > >-- >Kirk Wallace >http://www.wallacecompany.com/machine_shop/ >http://www.wallacecompany.com/E45/ > >------------------------------------------------------------------------------ >Site24x7 APM Insight: Get Deep Visibility into Application Performance >APM + Mobile APM + RUM: Monitor 3 App instances at just $35/Month >Monitor end-to-end web transactions and take corrective actions now >Troubleshoot faster and improve end-user experience. Signup Now! >http://pubads.g.doubleclick.net/gampad/clk?id=267308311&iu=/4140 >_______________________________________________ >Emc-users mailing list >Emc-users@lists.sourceforge.net >https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Site24x7 APM Insight: Get Deep Visibility into Application Performance APM + Mobile APM + RUM: Monitor 3 App instances at just $35/Month Monitor end-to-end web transactions and take corrective actions now Troubleshoot faster and improve end-user experience. Signup Now! http://pubads.g.doubleclick.net/gampad/clk?id=267308311&iu=/4140 _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
