Thanks Tom. On 1/22/16 6:31 PM, tom-...@bgp.nu wrote: > We ordered the 1024ppr encoder (EM1-2-1024-I): > http://www.usdigital.com/products/encoders/incremental/modules/EM1#description > with this disk: > http://www.usdigital.com/products/encoders/incremental/rotary/disks/DISK-2 > and this cable: > http://www.usdigital.com/products/cables-connectors/cables/5-pin/CA-C5-SH-NC > > Attached is a link to the only (stp) file I could find of the encoder mount. > I tapped the small holes in this bracket by hand with a 4-40 tap (don’t tell > anyone I used SAE screws on a metric only machine!) to mount the encoder to > it. The countersunk holes (using an M4 screw I believe) held this mount to > the backplate of the encoder housing with the same screws that held the EMCO > encoder to it.. I then adjusted the encoder wheel to line up in the slot as > it should using the stock Emco disk mounting hardware which is adjustable. I > can’t be sure that I didn’t modify the dimensions of this drawing for the > final part but I don’t recall doing that. I usually have my gcode or job > file but I can’t seem to find them. I was only making one so I may have > failed to save it… > > bgp.nu:/~tom/pub/EMCO120P-NewEncoderBrakt.stp > > -Tom >
-- Drew Rogge d...@dasrogges.com Phone: 8934OOO629OO4829631OOOOOOO ------------------------------------------------------------------------------ Site24x7 APM Insight: Get Deep Visibility into Application Performance APM + Mobile APM + RUM: Monitor 3 App instances at just $35/Month Monitor end-to-end web transactions and take corrective actions now Troubleshoot faster and improve end-user experience. Signup Now! http://pubads.g.doubleclick.net/gampad/clk?id=267308311&iu=/4140 _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
