On 18 October 2016 at 04:05, hubert <h...@hbahr.org> wrote: > My machine was initially setup by my vendor to mm. Personally I prefer > inches.
You can just set the GUI to display inches and issue a G20 (?) command and the machine will be, effectively, an imperial machine. (I am not sure it is G20, as I very rarely swap units, and the main linuxcnc site seems to be down from here) -- atp "A motorcycle is a bicycle with a pandemonium attachment and is designed for the especial use of mechanical geniuses, daredevils and lunatics." — George Fitch, Atlanta Constitution Newspaper, 1916 ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users