Hello AllShould I ground both ends of the shield for shielded pair? I am not sure what the best practice is see pdf attached for what I have now in black and the chunk in red I am not sure about.
The only other connections I have are:
- 24 volt supply for the mesa board going into TB3 pin22 as +24vdc
- the corresponding ground from the power supply going into TB3
pin 23
- a jumper going from IO ground pin 9 on JP4 of the servo drive to
TB3 pin 24
Thanks for any help and advice linden
Step and Direction Axis 0.pdf
Description: Adobe PDF document
------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
