On Fri, 2017-04-21 at 09:57 +0100, andy pugh wrote: > On 21 April 2017 at 09:23, Valerio Bellizzomi <vale...@selnet.org> wrote: > > Hello, > > I am trying to configure motors in pncconf with 7i76 board, > > I have selected the tab 'connector 2' and then selected a X-Axis StepGen > > which shows a StepGen-A and DirGen-B, but testing the motor with the > > panel it doesn'tg move. is this the right thing to do? > > Do the drives also need an "enable" input?
There is an optional ENA, but it sounds like a disable actually. On the drive there is a green led that is on (and the red led is off). > Is the motor locked and not moving, or can you move it by hand? > it is locked, that means current is flowing through the windings. ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
