On Sat, 2017-04-22 at 10:24 +0200, Valerio Bellizzomi wrote: > On Fri, 2017-04-21 at 11:56 +0100, andy pugh wrote: > > On 21 April 2017 at 11:45, Valerio Bellizzomi <vale...@selnet.org> wrote: > > > The X stepgen is show as 5 in the tab, and as > > > hm2_5i25.0.stepgen.05.counts in the test window, and it is changing > > > while I press the movement button > > > > I think this is the problem. > > > > https://github.com/LinuxCNC/hostmot2-firmware/blob/master/src/PIN_7I76x2_34.vhd > > > > Shows stepgen.05 to be on the expansion connector, not the DB25. > > > > Configure the X axis to be on Connector 3.
Hello, What does it means when motor vibrates and makes sounds ? The test window of pncconf is limited to 5000 and has disabled arrow control, that means we can't set nothing higher than 5000. So, once generated the config files with pncconf, I have edited the files by hand, and now I am testing with Axis. now I have set the parameters as follows: step on-time 5000 step space 5000 dir setup 10000 dir hold 10000 When the motor is at rest (before any jog command within Axis), it does not vibrate. But once a command is given, when it goes at rest again it vibrates and makes sounds, until I disable from the Axis interface. ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
