On Fri, 2017-04-21 at 12:53 +0100, andy pugh wrote: > On 21 April 2017 at 12:43, Valerio Bellizzomi <vale...@selnet.org> wrote: > > > the current parameters are, step on-time 3000, step space 3000, dir hold > > 5000, dir setup 5000 > > > > ok, that's a little step forward :-) > > It is rarely necessary to make the step and space lengths as short as > possible, you tend to run into physical limits first. > Try 5000 for step-length and step-space.
It is better but still some glitch, I can't set anything higher than 5000, the test window has disabled control arrow at 5000, in this condition the motor vibrates or moves alone very slowly, I would like to rise the dir-setup and dir-hold to 10000 but the test window doesn't allow this. > You can also try inverting the step pulse polarity. > done with approximately same results ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
