I have one of those motors. On the Z of my mill, with a 60 volt psu, very
poor performance. 27 ipm or stall lifting the head on the G0704.


With the 860 drive and 48 volts I could only get about 60 ipm . The
automation direct ( kelling) drives at 120 volt really make the difference,
far less motor heating as well.
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to