On Fri, 11 May 2018, jeremy youngs wrote:
Date: Fri, 11 May 2018 08:54:25 -0500
From: jeremy youngs <[email protected]>
Reply-To: "Enhanced Machine Controller (EMC)"
<[email protected]>
To: "Enhanced Machine Controller (EMC)" <[email protected]>
Subject: Re: [Emc-users] 7i90 not listed in pnc
From the forum
PCW replied the topic: 7i90 questions
A couple things
Do you really have two loadrt hm2_7i90 lines in your hal file? that wont
work
also you cannot specify firmware for a 7I90 (or most newer mesa cards)
since the configuration is
preloaded in flash memory
loadrt hostmot2
loadrt hm2_7i90
should just work (at 0x378 since thats the default PP address))
So do I or don't I have to flash this card ? I'm about as confused as it
gets .
You need only flash the card with new firmware if you need different firmware
than what is currently loaded. You cannot specify firmware on the loadrt line
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
Peter Wallace
Mesa Electronics
(\__/)
(='.'=) This is Bunny. Copy and paste bunny into your
(")_(") signature to help him gain world domination.
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
